Pickit3 issue
 
Notifications
Clear all

[Sticky] Pickit3 issue

14 Posts
6 Users
0 Reactions
57.5 K Views
james70818
Posts: 2045
Topic starter
(@james70818)
Noble Member
Joined: 19 years ago
[#10565]

I got my Pickit3 in today. I downloaded the latest version of MPLAB v8.43 and installed it. I go to the Programmer tab and select the PicKit3, teh output screen says no PicKit3 Connected. I connect it, and it starts destecting. The Connecting status bar on teh bottom left just scrolls over and over. On the pickit3 I have Green Power, Blue Active, and it looks like the Status LED has both the red and green leds on. All leds are solid on, with no blinking. Does this mean it is a bad PicKit?


13 Replies
steve_hirst
Posts: 296
(@steve-hirst)
Reputable Member
Joined: 17 years ago

mine just has green power and blue active lit.status light flashes red then goes solid green when selected. you might try rebooting.


Reply
james70818
Posts: 2045
Topic starter
(@james70818)
Noble Member
Joined: 19 years ago

Steve, When you first plug it in do all of the lights come on?


Reply
steve_hirst
Posts: 296
(@steve-hirst)
Reputable Member
Joined: 17 years ago

When I plug it in, no program running,the power and active light come on but no status


Reply
james70818
Posts: 2045
Topic starter
(@james70818)
Noble Member
Joined: 19 years ago

ok, I pluged it into another laptop I was working on then back to my machine and it is fine.

Now in MPLAB I get an error

PICkit 3 detected
Connecting to PICkit 3...
Firmware Suite Version...... 01.25.14
Firmware type......................Midrange
PICkit 3 Connected.
PK3Err0045: You must connect to a target device to use PICkit
3.


Reply
Page 1 / 3
Share: