Pic Programming Tro...
 
Notifications
Clear all

Pic Programming Troubles

12 Posts
6 Users
0 Reactions
8,556 Views
Posts: 24
Topic starter
(@ebenne)
Eminent Member
Joined: 16 years ago

Here are the pictures of the where I have pin 1 and the bottom of the board

IMG 2710
IMG 2711

Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Here is a link to some pictures of the pinout: https://www.google.com/search?q=pickit+3+pinout&espv=2&biw=1536&bih=758&tbm=isch&imgil=YLkit3f6XtFqJM%253A%253BXNs5A3rlQwddOM%253Bhttp%25253A%25252F%25252Fjumperone.com%25252F2011%25252F10%25252Fusing-microcontrollers%25252F&source=iu&pf=m&fir=YLkit3f6XtFqJM%253A%252CXNs5A3rlQwddOM%252C_&usg=__FB47rC_pYZrYi-0ngFPTuEXQ8e4%3D&ved=0CCYQyjdqFQoTCPrWu42klskCFcLYHgodkS8AKA&ei=nH9KVvqYE8Kxe5HfgMAC#imgrc=YLkit3f6XtFqJM%3A&usg=__FB47rC_pYZrYi-0ngFPTuEXQ8e4%3D

I am not familiar with the socket board you are using but it looks like the LVP pin is missing. Not sure if it is needed but it is a difference. On that page there is a picture that show how the wires are supposed to reach the PIC. I would use an ohm meter to make sure they are getting to the proper places. That will also tell you if you have the chip in the correct spot in the socket.


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

The 8,14,18,20-pin microcontroller aligned on the left 8P/14P/18P/20P flag line (B), shorting cap on the B position. think setting should be B 2/3 2/3


Reply
imbluenote
Posts: 1615
(@imbluenote)
Noble Member
Joined: 15 years ago

I agree with taz move the jumpers to the correct settings and pin 1 on the pic should be at pin 11 on the socket


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

yeah does look like it might go down 1 more space from where he has it yeah looked he has it at 36 on the side should line with 35


Reply
Page 2 / 3
Share: