Mixing pic codes
 
Notifications
Clear all

Mixing pic codes

13 Posts
4 Users
0 Reactions
12.5 K Views
Posts: 188
Topic starter
(@johnbyrne)
Estimable Member
Joined: 19 years ago
[#56810]

Apologies if this has been covered but I can't figure out what search words to use.

My old Renard 16 (Xmus) boards use the pic code NOT designed for LEDs. (PMW ?? I forget the terminology but not important). In years past when I needed to drive an LED flood I'd attached a string of AC lights in the circuit so it will latch. I want to get away from that. I know I can flash PIC chips and change them all out but I hate fixing things that are not broken and I only need LED capability on a couple of boards, not all 8 of them. The question is can I mix the PIC codes or do all Renard boards in the daisy chain need to use the same PIC code? One step further, a Renard 16 board utilizes 2 PIC chips each driving 8 SSRs. Can I mix code versions on the single boards? My goal is to limit how many PIC chips I'll need to flash and change out.

I know I could flash chips and test but honestly being a Mechanical Engineer, when I get to board level it makes me nervous and I'd love to not touch something that works.

Thank you very much in advance
John


12 Replies
Posts: 2214
(@ctmal)
Famed Member
Joined: 19 years ago

You're fine to mix and match the pwm settings as long as all the pics are using the same baud rate. The same should go for mixing and matching on a single board but I would switch the full board with the pwm configuration while you have that board open. I personally use the pwm configuration on all my Renards to avoid any issues.


Reply
Posts: 188
Topic starter
(@johnbyrne)
Estimable Member
Joined: 19 years ago

Thank you much. Yeah I wish I had used the PWM originally but that was 2007 lol. I've slept since then so not sure why I didn't other than maybe thinking I'd reduce power consumption a bit. Thank you again.


Reply
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago

I think your issue is the Triacs on your old boards. When we switched to LED's, we found that the original Triacs would not latch with the lower current draw. Some folks started using 'snubbers', and some folks swapped out the original Triacs for newer more sensitive ones. It has been too long for me to remember part numbers, hopefully someone more familiar with them will chime in with that infol.


Reply
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

using non pwm, you reduce power consumed in the circuit that drives the triac. saves you a fraction of a penney over the entire show season.


Reply
Page 1 / 3
Share: