is my pickit 2 prog...
 
Notifications
Clear all

is my pickit 2 programming my chip ??

12 Posts
6 Users
0 Reactions
4,964 Views
Posts: 127
Topic starter
(@baboiler)
Estimable Member
Joined: 15 years ago
[#21786]

I am starting a new thread on this since I added a couple pictures to see if anyone can answer my questions.

I uninstalled pickit software I had loaded and started all over. Reloaded everything and followed the step by step referenced in link below.I also looked at the documents from the pickit setup that was provided and I think the 2 methods are basically the same. Everything goes as it should until I get to the point it says to check communication and the software should reconize the device.

Still not sure about this. I still get "parts in family are not auto detect". This is after I choose the 16F688 pic from the drop down menu and do the check communication. And it never tells me the device has been reconized. It sees the pickit but not the device. this is picure on the left.

But if I ignore that and continue on by bringing in the .hex file and then selecting write it works and verifies as is looks like it should. Picture on the right represents what I get if I do this. Does that look like the pic has been programmed? I know nothing about this stuff but it appears to me the pic was programmed with the renard firmware.

Any advise / thoughts are appreciated!

http://www.doityourselfchristmas.com/wiki/images/3/38/How_to_program_a_PIC.pdf

1
2

11 Replies
Wayne J
Posts: 7789
(@wayne-j)
Illustrious Member
Joined: 20 years ago

um, have you put it in the controller and try it yet?


Reply
Posts: 53
(@casanovass)
Trusted Member
Joined: 16 years ago

Have you installed the jumpers on the board? I know you want jumpers on all of one letter, if memory serves me correct it's "B" but I don't have it in front of me at the moment.


Reply
Posts: 127
Topic starter
(@baboiler)
Estimable Member
Joined: 15 years ago

No I have not had time to finish the board output lines yet. I have a bad feeling it is not going to work and I was hoping someone could see the pictures and tell me "yep - they are programmed!" That would eliminate that from what could possibly be wrong if I have to start trouble shooting. I had some pre programmed pic's lined up but I don't think those are going to happen now. Thats why I went ahead and got the programmer.

Yes I did install the jumpers. If I read/understood the instructions correctly the jumpers/shunts go on "C" for the 16F688's. I bought one of the pickit starter kits off of ebay. This one.
http://www.ebay.com/itm/ICSP-Adapter-8-14-pin-PIC-w-PICkit-2-USB-Programmer-/230432419578?pt=LH_DefaultDomain_0&hash=item35a6d7aefa


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 20 years ago

It appears that the part is programmed, because of the green 'verification' message in the later picture.


Reply
Page 1 / 3
Share: