Changing renard pic...
 
Notifications
Clear all

Changing renard pic code issues

37 Posts
7 Users
0 Reactions
26.8 K Views
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

Do not do any cutting or pasting (although I do wonder if this means the same thing to you as it does to me).

Instead, use notepad to open the file that you have downloaded, make the changes, and save it back again.


Reply
will3ishere
Posts: 327
Topic starter
(@will3ishere)
Reputable Member
Joined: 18 years ago

do i need an editor to change the pic code or can i not just make a change to it in note pad and save it as an asm file


Reply
will3ishere
Posts: 327
Topic starter
(@will3ishere)
Reputable Member
Joined: 18 years ago

from the way it sounds, i cant make changes in note pad? Do have a recommendation on an assembler to use, One that is not to difficult to use


Reply
Posts: 1592
(@ruppro)
Noble Member
Joined: 11 years ago

notepad is the editor, works fine that is what I do all mine with. Just open notepad, the goto File => Open, Browse to and select the .asm that you downloaded and works. Make the appropriate changes (remove ;; in front of 115200 line, add ;; in front of 57600 line, change PMW 1 or 0), and then File => Save


Reply
will3ishere
Posts: 327
Topic starter
(@will3ishere)
Reputable Member
Joined: 18 years ago

in the wiki the renard ss operational firmware states this
#define CLOCKRATE 18432000
#define BAUDRATE 57600
there are no semicolons in the code at that point
i am assuming this is where i would make the change for baudrate


Reply
Page 3 / 8
Share: