Boards with differe...
 
Notifications
Clear all

Boards with different baud rates

11 Posts
5 Users
0 Reactions
21 K Views
Posts: 123
Topic starter
(@yellowdog87)
Estimable Member
Joined: 12 years ago
[#47942]

I’m curious to what happens when different boards have different baud rates. I’m using ss24 right now but am looking at buying a 24hc over in the buy sale section. My only question is the board I’m looking at is a different baud rate than the ones I have and didn’t know if they would work with each other or not?

Sent from my iPhone using Tapatalk


10 Replies
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago
yellowdog87 wrote:I’m curious to what happens when different boards have different baud rates. I’m using ss24 right now but am looking at buying a 24hc over in the buy sale section. My only question is the board I’m looking at is a different baud rate than the ones I have and didn’t know if they would work with each other or not?

Sent from my iPhone using Tapatalk

you can ask that person if they can re-flash the chips to the baud rate you have on your ss24 or you would have to run each board off its own port set at that baud rate for the boards


Reply
Posts: 123
Topic starter
(@yellowdog87)
Estimable Member
Joined: 12 years ago

Ok thanks. one more question, what’s the difference in baud rates? Is one better than the other?

Sent from my iPhone using Tapatalk


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Faster = more channels at a higher refresh rate and shorter distance before the signal degrades. Shorter is a relative term. If you are using RS485 at 234Kbs you may only get a few hundred feet between the data source and destination vs over 1000' at 56Kbs (using a good quality usb dongle). For most people 100' is more than they will ever need so the distance point is often moot.

Too fast and some of the controllers can't keep up. Too fast is implementation dependent. Good code runs faster than not so good code. Better hardware runs faster than not so good hardware.


Reply
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago

To keep it simple, the Baud rate could be thought of as a frequency. The controllers need to be programmed at the same frequency to talk to each other. The frequency (baud rate) is hard coded (flashed) on to the microchips on the controller. The faster the baud rate, the more channels you can run off of one Com Port (or dongle). The Renard data stream is called RS485, and is very robust, and can travel hundreds of feet before it starts to degrade. The chips are flashed with a Pic Programmer. If you don't have one, maybe try to find someone local to you that can help out. If you are going to continue to run Renards, I strongly suggest you purchase a PIC Programmer as the chips some times need to be reflashed from year to year.


Reply
Page 1 / 3
Share: