hp server psu
 
Notifications
Clear all

hp server psu

21 Posts
4 Users
0 Reactions
9,739 Views
wilmar
Posts: 2115
Topic starter
(@wilmar)
Noble Member
Joined: 8 years ago
[#52678]

So I got these in early is there a way to test these without the breakout board not sure when those will be here ?

Sent from my iPhone using Tapatalk


20 Replies
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago
wilmar wrote:So I got these in early is there a way to test these without the breakout board not sure when those will be here ?

Sent from my iPhone using Tapatalk

There should be contacts on the other end where the breakout boards attaches.

Sent from my SM-T710 using Tapatalk


Reply
wilmar
Posts: 2115
Topic starter
(@wilmar)
Noble Member
Joined: 8 years ago
pmiller wrote:There should be contacts on the other end where the breakout boards attaches.

Sent from my SM-T710 using Tapatalk

Yea I’ve seen videos on using a jumper wire to turn them on but I’m one that likes to hear from others that have done it rather than a video on you tube

Sent from my iPhone using Tapatalk


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago
wilmar wrote:Yea I’ve seen videos on using a jumper wire to turn them on but I’m one that likes to hear from others that have done it rather than a video on you tube

Sent from my iPhone using Tapatalk

I don't remember if you got a controller set up from me with a server supply and breakout board.

Sent from my SM-T710 using Tapatalk


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

The hard part is finding the right pot to drop the voltage. Most server supplies are outputting 12.1 to 12.2 volts. I found the right pot and drilled a hole in the side of the server case to access the pot.

Sent from my SM-T710 using Tapatalk


Reply
Page 1 / 5
Share: