Emergency problem.....
 
Notifications
Clear all

Emergency problem...

8 Posts
3 Users
0 Reactions
2,886 Views
MacabreRob
Posts: 215
Topic starter
(@macabrerob)
Reputable Member
Joined: 15 years ago
[#16858]

I am running with a hacked Mr Christmas running 6 channels and an Arduino controlling 2 relay boards with 4 and 8 channels respectively. When I originally tested, flipping each channel on and off, it seemed fine, but when I added the Generic Serial for the arduino and Basic Parallel for the Mr Christmas, it almost seems like it's randomly flipping channels off and on. When I sequenced my songs, I rearranged the channels, but it is still weird if I restore the order back to the orginal.

One question, do I need to specify 8 channels for the basic parallel (ie add 2 unused channels)? As for the arduino, I saw in the Generic Serial there was options for a Header and a Footer. Do I need to alter my arduino code to look for that to clear all the pins (set them to low) when I encounter one of these bits of data? If so, how do I detect that.

I was going to do a mini version of my light show for the office trick or treat tomorrow (Friday) but now it looks like I might not be able to do anything. I despair at being able to do any light show now if I can't get this resolved by Monday. I was also going to start the light show at my house this weekend.

All that work... possibly in the toilet.


7 Replies
Posts: 371
(@gebbinn)
Reputable Member
Joined: 16 years ago

I ran a hacked Mr. Christmas last year and I only had 6 channels on the basic parallel. You can use a program called Parmon (see attatchments) to check the output of your parallel port while running vixen to verify functionality. Vixen should turn the pin on in the parallel port that corresponds to the channel in the Mr. C. Parmon will show the pin as on while vixen has it on. It is a simple program that is pretty easy to figure out.


Reply
kychristmas
Posts: 3955
(@kychristmas)
Famed Member
Joined: 18 years ago

Also, make sure the different plugins are assigned to the correct channels. By default when you add a plugin, I believe its assigned all of your channels by default.


Reply
MacabreRob
Posts: 215
Topic starter
(@macabrerob)
Reputable Member
Joined: 15 years ago

The Mr Christmas channels seem fine running under the Basic Parallel. And when I ran a test of the 12 channels running on the Arduino, they seemed to work. but when I have both output plugins running, things get all hinky.


Reply
Posts: 371
(@gebbinn)
Reputable Member
Joined: 16 years ago

I would refer back to Kelly's post then, and make sure that your plugins are set for the proper channels. I dont know anything about the arduino, so I cannot help you.


Reply
Page 1 / 2
Share: