MiniTree sizes
 
Notifications
Clear all

MiniTree sizes

7 Posts
4 Users
0 Reactions
4,895 Views
Matt_Edwards
Posts: 2664
Topic starter
(@matt-edwards)
Famed Member
Joined: 18 years ago
[#18159]

This year the other family members are being induced to start decorating their houses by receiving some custom decorations. To start each family will receive 2 mini trees. they will have 4 x100 count LEDs strings on each tree. LED spacing is 100mm ( standard Big-W String here in Australia) The trees will be welded 1/4 mild steel.
I am thinking along the lines of a triangular shaped tree. But I am unsure of tree size, as in height and width as well as shape.

given a total of 400 LEDs, can anyone recommend a size?


6 Replies
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

I'll guess about 1 meter tall, and with 4 strings of leds, they'll be covered with wire... depending, of course, on how wide you make the base because that will make a big difference... 3 strings on a 1 meter tall with triangular base tree with the base 35cm on a side fills it up very well; 4 strings would be even more full.


Reply
Posts: 12
(@pipersmall)
Active Member
Joined: 15 years ago

hi Matt

I found a 90cm obelisk plant trainer from bunnings ($10) that I had 2x 200 light bigw strings on that worked quite well.

Hamish


Reply
Matt_Edwards
Posts: 2664
Topic starter
(@matt-edwards)
Famed Member
Joined: 18 years ago

When I got home last night, I whacked together a 1000x350mm Triangular Pyramid and a 900mm tomato cage, ( I used these for my RGB Spiral Mini trees).

Both had 400 LEDs.
Last night I was unable to upload short Videos of the two running. I am have better luck tonight.

I am definitely in favour of the triangular Pyramid. The overall design still needs refining to make it easier for make and wrap. I am thinking of adding 3 vertical strips of 150mm cavity mesh so the strings can be cable tied and won't slip up.
ATM the gap at the bottom is too big, I want it to be about a 50 to 100 mm before the LEDs start wrapping.

MiniTrees test 1

Reply
Materdaddy
Posts: 2368
(@materdaddy)
Famed Member
Joined: 16 years ago

I'll grab a couple of pictures of mine today which I've been meaning to do. They are very similar to these in design: http://belardolights.com/jtree.html

In US:
I bought 12' cold rolled steel and cut them into three pieces roughly 3'3" and two pieces at 1'1.5". This gave me 1 tree from each 12' piece.
Again, in better units:
I bought 3.6576 meter cold rolled steel and cut them into three pieces roughly 0.9906 meters and two pieces at 0.3429 meters. This gave me 1 tree from each 3.6576 piece.

I didn't make the little "hook" shown, I simply bought some S-hooks to hang them once done. I love the stackable design so storage of my trees takes (relatively) little space.


Reply
Page 1 / 2
Share: