I am using the Monkhouse base and I can't recommend it enough. The tree is 20' tall and holds over 2200 C9 pixels. I have used the screw in stakes, pounding in Rebar at an angle and the failure point is the dirt. Everything I put in the ground is pulled towards the tree. I live in Southern California, so no freezing ground. It does get windy and the strands move quite a bit. The top of the tree sways but I'm not concerned with it tipping all the way over, I'm just trying to make it more stable from the base only. This year I dug holes in my lawn and buried 4 inch pipe filled with concrete about 2 feet deep. It is also moving the dirt and making the holes wider. My next plan is to remove the pipe, which slides out of the ground, drive some rebar into the hole, put a new pipe in and fill it with concrete. This will help keep the pipe in the ground, but I'm afraid the hole will still expand from the horizontal force of the tree. The ground isn't flat so it's hard to put wood along the sides like Walter has shown. Any ideas?
Thanks, Chris
It is the top swaying that is causing the base to move and pull at your anchors, you need to add lines to the top of the tree to stabilize it and that should reduce the stress at the base.
Today i set up the base and the tree is only about 10' tall because I didn't extend it or add any lights. I was just pushing on the pole and it was moving the dirt in the hole. I was hoping to avoid tethering from 20' up but if that helps, I might have to.
I use a different tactic on my mega tree vs my Star Flake poles. Either should work.
Mega tree uses a base from ChristmasLightshow.com. It is the standard cross at the bottom with 1 1/2" arms. I stake them so they can't twist and run guy wires to the top. This is the best way by far.
On the Star Flake poles I use a 4' piece of deep Unistrut pounded in the ground vertically next to the pole. I leave 2' out of the ground. I put the pole nested in the trough of the Strut and used and used two U bolts, one high, one low, to hold the pole to the Strut. I was using flag poles so I only put guy wires up to the 4' mark on the poles. The top whipped in strong winds pretty good but the bottom 4' was like it was in concrete. Never moved.
BTW, how are you putting your anchors in? The "screw in stakes" or trailer anchors are meant to be put in so the guy wires are pulling them directly out of the ground.. unlike with regular stakes you pound in, you want those to be perpendicular to the pull of the wire as much as possible.

