Data wiring configu...
 
Notifications
Clear all

Data wiring configuration

19 Posts
5 Users
0 Reactions
11.6 K Views
Posts: 255
Topic starter
(@townshend-lights)
Reputable Member
Joined: 11 years ago
[#51523]

I'm in the process of wiring up my flat Mega tree.
It will run 12 strings of WS2812b strings 2.5m length 75 nodes per string. So 6 150 strips in total. 900 nodes.

As I'm using Xlights, I was going to wire it up as per the wiring diagram. So before I get into this I had some questions.

Is the following best practice?

Each string will run from the bottom up as per xlights. So node 1 at the bottom node 75 at the top.
I'll power inject at the bottom.
Maybe the top too if needed.
Now as for the data. I want to run one output from my Node D1 Mini into node 1 string one then out of node 75, back down the tree and into node one string two and so on.

Will this work?
or Should I use two pins at 450 nodes each?


18 Replies
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Yes it will work BUT, it is simpler to run the data up one strip cross directly to the next strip and run down the next strip. This is called zig-zag and is supported by most controllers. This also means that you mount the strips in alternating directions. It keeps the data lines between strips much shorter.


Reply
Posts: 255
Topic starter
(@townshend-lights)
Reputable Member
Joined: 11 years ago

How would I configure this layout in xlights? A custom model?

Sent from my YAL-L21 using Tapatalk


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

First decide where you are going to apply the zig-zag operation. If you plan to do it in your controller then you leave xLights thinking that you are running data from bottom to top on all legs. If you plan to do it in xLights, then an xLights person needs to chime in. I am a vixen guy.


Reply
Posts: 1592
(@ruppro)
Noble Member
Joined: 11 years ago

In Xlights you set as 1 String and then X Strands (2,4,6...) and total # of nodes for all your strands (150, 300, 450...)


Reply
Page 1 / 4
Share: