2" rigid conduit co...
 
Notifications
Clear all

2" rigid conduit coupling stuck

8 Posts
4 Users
0 Reactions
4,915 Views
Posts: 447
Topic starter
(@glycerine)
Honorable Member
Joined: 7 years ago
[#52840]

So, I bought my rigid conduit for my ASAP yesterday. The 1.5 inch coupling is loose and removable, but I can't get the 2" one to budge. It looks like "zinc-it" or something similar was sprayed on the threads before the coupling was installed. Is this normal? I'm sure I can put it all together without removing that coupling, but I'd feel better if I were able to remove it if necessary. Any ideas on how to get it loose?


7 Replies
rayhjr
Posts: 972
(@rayhjr)
Noble Member
Joined: 12 years ago

Best case would be to put pipe in a vice or some tipe and turn coupling with large channel-lock pliers. Or maybe 2 large pliers, one on pipe and one on coupling turning in opposite directions. Or a strap wrench or pipe wrench, whatever you have or have access to. Maybe borrow from a friend or family member.
I would suggest clearing the threads with a wire brush once removed and applying a coat of never seize on them. Thin coat, a little goes a long way and if you get it on your hands it will wind up on everything, very messy but works wonders. Automotive stores sell it and it is basically the same thing that comes in small packages at the check out counter for spark plugs. That little pack would be more than enough for what you need. Hope this helps.

Sent from my SM-A505U using Tapatalk


Reply
Posts: 447
Topic starter
(@glycerine)
Honorable Member
Joined: 7 years ago
rayhjr wrote:Best case would be to put pipe in a vice or some tipe and turn coupling with large channel-lock pliers. Or maybe 2 large pliers, one on pipe and one on coupling turning in opposite directions. Or a strap wrench or pipe wrench, whatever you have or have access to. Maybe borrow from a friend or family member.
I would suggest clearing the threads with a wire brush once removed and applying a coat of never seize on them. Thin coat, a little goes a long way and if you get it on your hands it will wind up on everything, very messy but works wonders. Automotive stores sell it and it is basically the same thing that comes in small packages at the check out counter for spark plugs. That little pack would be more than enough for what you need. Hope this helps.

Sent from my SM-A505U using Tapatalk

I tried with 2 strap wrenches, but one strap kept slipping. I'm wondering if they normally come like this or someone might have returned this one after they sprayed whatever it is on there. I didn't notice at the store if they were all like this.
Thanks, I think I do have some anti-seize grease.


Reply
rayhjr
Posts: 972
(@rayhjr)
Noble Member
Joined: 12 years ago

They are dipped in galvanized but some couplings are harder to remove than others. It may have been sprayed, they don't want coupling to come off while being shipped but some are WAY Overdone.
Have you tried tapping on coupling. Don't beat, just tap to try to loosen? Just don't damage because you have to use it or return it.

Sent from my SM-A505U using Tapatalk


Reply
Posts: 447
Topic starter
(@glycerine)
Honorable Member
Joined: 7 years ago
rayhjr wrote:They are dipped in galvanized but some couplings are harder to remove than others. It may have been sprayed, they don't want coupling to come off while being shipped but some are WAY Overdone.
Have you tried tapping on coupling. Don't beat, just tap to try to loosen? Just don't damage because you have to use it or return it.

Sent from my SM-A505U using Tapatalk

I have not. I'll try that too.


Reply
Page 1 / 2
Share: