Hi has anyone used Ray Wu's meteor tubes in a display? I was thinking about hanging these from the lower branches of a real tree (maple) for a dripping effect.
https://www.aliexpress.com/item/32665807720.html
I'm not quite sure how these things wire up with a 4 wire connector.
Would appreciate if anyone has video of a similar thought.
Thanks
pyro2k wrote:
I'm not quite sure how these things wire up with a 4 wire connector.
There is 4 wires, they are like the icicle lights Ray sells.
2 wires if for power (+ & -) the other two wires is data. 1 data wire is data in, the other is data out.
These 'T' connectors take the 4-pin connector and make it into a 3pin male/female connector.
https://www.aliexpress.com/item/1859056875.html
This is the exact same wiring as 'icicle' lights and 'peace stake' lights that Ray sells.
Side note: I looked into these tubes but for 20 of them it was expensive. I went for sets of 'Peace stake' lights that Ray sells. Peace stake lights are just icicle lights with a 3 foot gap between each drop.
$12 per meteor is a bit up there. My trees all get dumb meteor showers, and I pay around $18 for a set of 6; RGB. I'm content with switching on and off entire trees, like an AC.
Where are you getting dumb meteor showers from?
I haven't actual used any of these with the 4 wires so this is all new to me. I was looking at peace stakes for next year so I will guess I will need to figure this out.
Do I need 1 of the "T" for every meteor tube that I want to hang?
