led strings with co...
 
Notifications
Clear all

led strings with controllers

7 Posts
5 Users
0 Reactions
2,973 Views
Posts: 127
Topic starter
(@t-jo13)
Estimable Member
Joined: 15 years ago
[#18403]

If I understand correctly, the controllers that are used on led lights. that allow them to do random things are 110v in and 12v out . If this is so then can I use a dc control board instead of the little controller that come on the string of lights?


6 Replies
Slite
Posts: 325
(@slite)
Reputable Member
Joined: 15 years ago

Which led strings are you refering too? There is like a gazillion different ones 🙂


Reply
Posts: 127
Topic starter
(@t-jo13)
Estimable Member
Joined: 15 years ago

they are GE 50 ct. I will try and get a picture of the controller to better address the question if that will help


Reply
Posts: 180
(@jonpro03)
Estimable Member
Joined: 15 years ago

I plan on doing exactly that. I've converted a couple of AC LED strings to 12V DC already. It's not a particularly hard thing to do, just time consuming. I'm also working on a DIY 12V DC controller that will power the strings directly. My intent is to have 32 channels of LED strings powered by one computer power supply.

Advantages are simple software PWM dimming, low power consumption, no extension cords, and uber cheap relay boards.
Disadvantage is lots of time spent converting AC strings to DC. 🙁


Reply
CaptKirk
Posts: 2200
(@captkirk)
Noble Member
Joined: 16 years ago

I know for a fact that the cheap China strings you can find on Ebay by searching for "100 LED 10M" rectify 110V AC to 110-168V DC ( I measure them closer to 110V DC and if there were a filter cap, they would be closer to 168VDC but then not dim well) and switch that with low current SSRs/triacs in the control box. I would bet others do something similar- it just depends on how many light circuits the string is proken into. It is much cheaper for a 50 count to do ONE light circuit and have each LED take 3 or 3.3V * 50 = 150 to 165V DC with no resistors. You can tell by pulling out ONE LED and see if the whole string goes out.

Kirk


Reply
Page 1 / 2
Share: