Ikea Lanterns Const...
 
Notifications
Clear all

Ikea Lanterns Construction Notes.

8 Posts
4 Users
0 Reactions
2,502 Views
Posts: 384
Topic starter
(@burtonmadness)
Honorable Member
Joined: 14 years ago
[#31829]

I was asked to upload some construction notes for my LED pixels inside Ikea Lanterns: Here we go..

BOM:

  • 24x Ikea Silver Tea Light Lanterns
  • 24x LED Pixels (I'm using 12x square type Pixels from DiyLEDExpress)
  • 24x 3-pin JST pig-tails
  • 2x Flourescent Tube Protectors
  • Frosted Glass spray

Tools:

  • Hot Glue gun
  • Junior Hacksaw
  • 1/2" Drill bit (and drill)
  • Soldering Iron (and solder)
  • Reams of heat shrink

Firstly cut up the flourscent tube protectors into 3.5" pieces and paint them with the Frosted Glass spray.

image7

image6

Since the intra-spacing of the pixels was not large enough, I decided to solder pig-tails to the pixels, rather than crimping the jst connectors.

image5

And then hot glue the pixels to the top of the now-frosted tubes.

image3

Drill a 1/2" hole into the top of the lantern so that the jst connectors can fit through.

image1

Hot glue the tube to the bottom of the lantern (they fit nice and snug into the tea-light holder)

Thread the jst-connectors through hole and then the finished product..


7 Replies
Posts: 384
Topic starter
(@burtonmadness)
Honorable Member
Joined: 14 years ago
image8

Reply
Posts: 3277
 Jrd
(@jrd)
Famed Member
Joined: 19 years ago

That's pretty sweet, thanks for sharing!


Reply
ksmith247
Posts: 418
(@ksmith247)
Honorable Member
Joined: 14 years ago

Looks great..good job.


Reply
Posts: 384
Topic starter
(@burtonmadness)
Honorable Member
Joined: 14 years ago

Once they are all strung up for my daughter's birthday party, I'll take some more piccies.

They'll look good in the front tree for both Halloween and Christmas.

/BM


Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

Just curious, did you fill in the hole once the connectors were through or did you leave them open?


Reply
Posts: 384
Topic starter
(@burtonmadness)
Honorable Member
Joined: 14 years ago

I filled the hole in with clear silicon, so water would not drip down.

/BM


Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

Thanks.


Reply
Share: