XxFriction
New member
Hello there,
This is my first time using this website, I must admit, it is full of really awesome work.
but I have just started using vixen and I seem to have a lot of trouble,
basically I want to do the followings:
-Control a normal (one colored) LED connected to Arduino from Vixen 3 (completed).
-Control two Arduino boards at the same time from Vixen 3 (completed).
-Control RGB LED (the ones with 4 wires) from Vixen 3 (I can't figure out what code or vixen effect to use, only thing I can do is to control each pin independently, so I only have 6 colors possible, how do I fully control the RGB LED colors from vixen ?).
-Control WS2812B single LED or a complete strip from Vixen 3.
-Control a servo motor from Vixen.
-Control the speed of a DC water pump from Vixen.
I need a little guidance, maybe people have done these before, so if you know any thread or code that have these possibilities I would really appreciate if you point me towards them.
thank you so much.
This is my first time using this website, I must admit, it is full of really awesome work.
but I have just started using vixen and I seem to have a lot of trouble,
basically I want to do the followings:
-Control a normal (one colored) LED connected to Arduino from Vixen 3 (completed).
-Control two Arduino boards at the same time from Vixen 3 (completed).
-Control RGB LED (the ones with 4 wires) from Vixen 3 (I can't figure out what code or vixen effect to use, only thing I can do is to control each pin independently, so I only have 6 colors possible, how do I fully control the RGB LED colors from vixen ?).
-Control WS2812B single LED or a complete strip from Vixen 3.
-Control a servo motor from Vixen.
-Control the speed of a DC water pump from Vixen.
I need a little guidance, maybe people have done these before, so if you know any thread or code that have these possibilities I would really appreciate if you point me towards them.
thank you so much.