XLights Odd Problem...
 
Notifications
Clear all

XLights Odd Problem - need help

12 Posts
5 Users
0 Reactions
5,139 Views
Posts: 144
Topic starter
(@travisb6989)
Estimable Member
Joined: 14 years ago
[#47584]

I am running xlights and have 4 vertical columns setup as matrix's. 2 of them work perfectly, the 3rd one has an interesting problem (4th i am building today). It is 54 pixels high with 4 rows.

When say doing a test sequence for the entire house in red, everything goes red except for the last 48 or so pixels in the 3rd column. They go green. I know control works because they will all turn white, or if the house blue they go red. I thought maybe it was a splice point where a new strand starts but it was the middle of a strand.

I have narrowed the problem down to xlights, at least i think. I came to this conclusion because if I run test patterns from the controller itself (e6804 from san devices) the matrix all turns to the same color.

I also tried cutting where the issue starts and removing the last correct pixel and connecting a new strand, but the problem is the same.

I am using RGB ws2811 square nodes from Holiday Coro.

Thanks!


11 Replies
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

can you post a screen shot of your setup page in xlights


Reply
Posts: 2229
(@plasmadrive)
Famed Member
Joined: 15 years ago

Could be a few things.. model setup.. or possibly a render issue. Sounds like you have them doing a variant of RGB or a channels is missing somewhere. Are you testing in the "test" section or running a sequence when you have the issue?


Reply
Posts: 423
(@keithsw1111)
Reputable Member
Joined: 11 years ago

My guest is it is a mismatch between the universe size in XLights and the controller. Maybe 510 vs 512.


Reply
Posts: 144
Topic starter
(@travisb6989)
Estimable Member
Joined: 14 years ago
TazChaLet wrote:can you post a screen shot of your setup page in xlights
1
2

3

Reply
Page 1 / 3
Share: