Question Re: comput...
 
Notifications
Clear all

Question Re: computer workflow...

9 Posts
7 Users
0 Reactions
4,830 Views
Posts: 19
Topic starter
(@steve3d2005)
Eminent Member
Joined: 6 years ago
[#53748]

Hi All,

Been playing around with Xlights and some of my house outline and currently the workflow is a pain. Any advice would be appreciated.

For now I have my Falcon F48 in the garage hooked up to a spare wifi router.

I do my sequencing on my desktop PC since the bigger monitor makes it easier. Then I copy the sequencing files to a network storage drive. Power up laptop, connect to home network and grab all of the sequencing files to laptop.
Then switch laptop over to the Christmas lights network to launch xscheduler and run the show.

That is an awful lot of steps, especially when I want to just make quick changes, push them to the lights and see the results in real time.

Are there any easier ways to do this that are possible?

I am thinking maybe a FPP would help in this regard, but not sure if that can connect both to my home network so I can push the files to it while simultaneously being connected to the Christmas light controller?

Thanks!
Steve


8 Replies
Posts: 409
(@dim-bulb)
Reputable Member
Joined: 9 years ago

I use a falcon pi player to run my show, it is connected to a separate show router. To upload from my computer all I do is disconnect from my home wifi to the show wifi, then upload.


Reply
Posts: 120
(@superdave)
Estimable Member
Joined: 13 years ago

You could add a wifi to your desktop, so you could upload to that other network.

Many people will also use a FPP (Raspberry Pi) to sit on both networks, and then proxy to the devices on the other network. it is on Page 57 of: https://falconchristmas.github.io/FPP_Manual(4.3).pdf


Reply
th182
Posts: 159
(@th182)
Estimable Member
Joined: 11 years ago
superdave wrote:You could add a wifi to your desktop, so you could upload to that other network.

Many people will also use a FPP (Raspberry Pi) to sit on both networks, and then proxy to the devices on the other network. it is on Page 57 of: https://falconchristmas.github.io/FPP_Manual(4.3).pdf

FPP with the Ethernet connection going to the controllers/light show network. Wifi going to home wifi.

Then on your sequencing computer go to the FPP web page using it's wifi IP address. From there you upload your sequences.

Once set up initially, there is no more changing networks or computers to upload sequences. And it still accomplishes the goal of keeping your show data off the home network as FPP only sends it over Ethernet.

Sent from my iPhone using Tapatalk


Reply
Posts: 401
(@kensington)
Reputable Member
Joined: 11 years ago

FPP can simplify your life. My setup:

Home network —> wifi extender in bridge mode —> show router —> network switch —> multiple FPPs, controllers, etc.

Then I have a static route configured on the home network router, so any device on the home network can reach any device on the show network.

The wifi extender is a TPlink wa701nd, but it can be swapped with a network cable if you can run cable from the home router (I’m too lazy to cut into walls and ceilings to fish the cable). The network switch can be eliminated if you only have a couple devices to attach and use the Ethernet ports in the show router. The FPP manual has an example of this kind of setup starting around page 96 under advanced options.


Reply
Page 1 / 2
Share: