Renard Stopped work...
 
Notifications
Clear all

Renard Stopped working after adding another E682

10 Posts
3 Users
0 Reactions
6,602 Views
Posts: 890
Topic starter
(@ben-bobbi)
Noble Member
Joined: 17 years ago
[#58438]

I have been messing with this since Friday. i have my RenSS24's running off Rasberry Pi with the E682's. I added another E682 board to add more props. After many back and forth to get universe counts / channels correct, i got the new E682 working as expected (tried to add after the Renard channels). I moved the Renard controllers to the next universe which is 85. This is very similar to how it was setup prior to adding the new board. The last universe on the E682 is 84, last one outputting is 80. Confirmed in Vixen config settings and FPP output settings. I don't see anywhere in FPP to assign output universe for the Renard, which is listed on the OTHER tab with Renard type selected. It was ran this way prior to new board.

Its my understanding that Renard needs to be the last output, and the export from Vixen is set up that way. So all that should match.

Board 1 was running as expected. Boards 2-5 were all stuck on. I assumed this meant output from board 1 was bad, so i switched cables and made board 2 the new board 1. That board played like it was board 1, but 3-5 still stuck on. I did this for all 5 boards and now they are off. Put board 1 back as board 1, and it plays as expected, but still nothing on boards 2-5, but they are not stuck on anymore.

Any suggestions are appreciated even the obvious ones, as i am sure my frustrations is overlooking something simple.

renard 2024 vixen
Renard 2024 FPP
E682 last outputs

9 Replies
Posts: 429
(@mikekrebs)
Reputable Member
Joined: 12 years ago

In Vixen, isn't there a co-universes file or something similar that is or can be generated that will have FPP information in it? Look in there.
All the boards are running standard Renard?


Reply
Posts: 890
Topic starter
(@ben-bobbi)
Noble Member
Joined: 17 years ago

this looks right to me

universe output

Reply
Posts: 2214
(@ctmal)
Famed Member
Joined: 19 years ago

Do the Renards work correctly if you use FPP's test display section? I would just have it run from 20734 to the end for testing.


Reply
Posts: 890
Topic starter
(@ben-bobbi)
Noble Member
Joined: 17 years ago

need to correct above image, that was not the latest export universe file, the universe is set to 85


Reply
Page 1 / 2
Share: