Ren48LSD question
 
Notifications
Clear all

Ren48LSD question

12 Posts
2 Users
0 Reactions
3,485 Views
jlowe
Posts: 952
Topic starter
(@jlowe)
Noble Member
Joined: 16 years ago
[#17381]

I know there may not be "stupid questions", but I sure have one that I'm not totally proud of...

In the trouble-shooting guide of the Ren48LSD documentation, there is this line: "With all six PICs installed, measure the voltage on pin 2 (from ground) on all PICs"

How do I do this? On the regular renard board, there is a "ground" point on the board itself. I don't find one on this board, so... do I just touch one of the multimeter leads to a metal surface? I don't know how to do this...


11 Replies
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

You can use pin 14 for ground and measure pin 2 on any PIC - I'll update the Wiki to clarify that.


Reply
jlowe
Posts: 952
Topic starter
(@jlowe)
Noble Member
Joined: 16 years ago

Thanks man!


Reply
jlowe
Posts: 952
Topic starter
(@jlowe)
Noble Member
Joined: 16 years ago

What if mine show a reading of 1.35v-1.40v ?


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Pull all of the PICs (carefully) and re-measure - it should go higher - closer to 5v. Check all the pin 2's (they are all connected together) and traces back to the oscillator - reflow them for grins. Double-check the orientation of the oscillator - there is a "squared" off corner - that should point to the DC IN 1 terminal block (upper right). Double check/reflow all the pins on the oscillator. The lower left (looking from top-side with DC IN's on right) should read the same voltage as pin 2 on the PICs. The lower right should read +5v and the upper left should be ground. Are you sure the PICs are actually programmed?


Reply
Page 1 / 3
Share: