I'm having a problem with an ss24 that was working perfectly last year. I ran through troubleshooting and found none of the LEDS lights but the channels light up when jumped. I checked the test points for 5v and they all come up 4.26. I flashed a brand new pic with dmx hex from last time that was already compiled and known to work.
Now channels 1-7 stay on and nothing else changes when toggling channels on and off.
What is significant about ch1-7 that they would stay on??? Board looks ok no broken solder points that I can see.
Any help would be appreciated!
Thanks,
Wayne
I cant help with DMX, but as for the LEDs, do you have the shunt on JP3?
My guess is that the PICs are actually blanked. Did you do an erase before doing the write? If you load the hex and then do a blank check and then do a write, you will end up with a blank PIC because the erase clears the hex file contents you read in.
Wayne J wrote:I cant help with DMX, but as for the LEDs, do you have the shunt on JP3?
Yes shunt is on. I tested as per the troubleshooting guide the jp3 a d got 5v
I bought 2 more ss24s from your group buy last year and got EXTRA pics. I used the pic marked with a silver 1 in first slot on the board as a replacement to try.
When I fired it up the string of lights I had plugged into #3 blinked a few times in a pattern.
LightUpMA wrote:Yes shunt is on. I tested as per the troubleshooting guide the jp3 a d got 5vI bought 2 more ss24s from your group buy last year and got EXTRA pics. I used the pic marked with a silver 1 in first slot on the board as a replacement to try.
When I fired it up the string of lights I had plugged into #3 blinked a few times in a pattern.
My guess is that is a PIC loaded with Diagnostic Firmware.
