24ss help please
 
Notifications
Clear all

24ss help please

9 Posts
6 Users
0 Reactions
2,585 Views
Posts: 127
Topic starter
(@baboiler)
Estimable Member
Joined: 15 years ago
[#27334]

Hello all. Finished putting together my 2nd new 24ss board today. I started going thru the test procedure from the wiki. My "SD" LED would not light. Went thru the whole procedure for checking volts in each socket. The socket for "SD" had no reading (all other read 3.5). So looks like I may have put LED in backwards. I tried to take it out to reverse it and that is when my real trouble started. The square pad on bottom of PCB came off and I pulled one of the leads out of the LED. great!! So - can I go tomorrow and get one of those LED's at Radio Shack or am I going to have to order it? What do I do about the pad? Is the LED required or is it purely diagnostics? 1st board went great. Worked first time! Guess my luck ran out : ( Any help appreciated!


8 Replies
imbluenote
Posts: 1615
(@imbluenote)
Noble Member
Joined: 15 years ago

To my knowledge the led are only an indicator and not necessary to use it,BUT, it is useful to have when there are problems.

You can get another led from the shack and put it in there. Just run a piece of wire from the led leg to the back to where the trace goes.


Reply
Wayne J
Posts: 7789
(@wayne-j)
Illustrious Member
Joined: 20 years ago
imbluenote wrote:To my knowledge the led are only an indicator and not necessary to use it,BUT, it is useful to have when there are problems.

You can get another led from the shack and put it in there. Just run a piece of wire from the led leg to the back to where the trace goes.

Yep, just there for diagnostics and is not "needed".
If it was the square pad on the bottom that was the only one damaged, then you are in luck! The actual trace is on top, so just solder the LED on the top pad when you put in a new one.


Reply
Posts: 127
Topic starter
(@baboiler)
Estimable Member
Joined: 15 years ago

Thanks guys. After seeing these responses I thought I would just move ahead with the testing. So I took "not needed" as I can leave the holes on the pcb open where the led was supposed to go. I must be wrong on that because now I don't seem to have power anywhere. Nothing at the +5 test point and no power light. Guess I'll have to wait until tomorrow and see if our Radio Shack has an led for me. I have my doubts. Our store is small and I have a track record of not finding what I'm looking for there. Man I was hoping to have this thing done tonight!


Reply
Wayne J
Posts: 7789
(@wayne-j)
Illustrious Member
Joined: 20 years ago

That LED has nothing to do with the 5v power input. If you lost power then something else is at fault.


Reply
Page 1 / 2
Share: