My initial idea was to try to find a way to allow a DC controller (such as an Ren48LSD) to use A/C SSRs successfully in something other than an on/off only mode. So I came across the idea of possibly using a voltage comparator to capture the DC signal with the thought that a "dirty" DC wall wart might suffice. A "dirty" one is one that has perhaps a full wave rectifier after the transformer but not much else -- no capacitors or anything to try to smooth out the current. Of course, what this would mean is that right after the rectifier, you have only a DC signal but it still has a wave pattern, from essentially zero to its +VMAX.
With that in mind, I used an LM393N voltage comparator as a sort of zero-crossing detector. Here's what it's signal looks like when connected to a "dirty" wall wart. I'm not exactly sure what I'm going to do with this idea, but in a way, it seems to open up the possibility to create a sort of pass-thru dongle inside a piece of shrink tube that passes the DC power through to the 48LSD but has an additional connection wire that would go to pin 4 of one of the PIC16F688 chips on a Ren48LSD to allow that individual PIC to serve a pair 4-channel A/C SSRs. My Ren48LSD is in use in my show and with our current sub-zero temps, will be frozen-in outside for another couple months and I won't be able to test it. But I thought I'd toss this idea out to others to see whether this idea may have any merit...
So buy grabbing the AC spikes from dirty DC then you would convert it to sync with the AC output of the transformer being rectified,,,yes?
That was the idea...
I wish i knew what you guys were talking about. lol
It's called Dirkspeak .........:freak:

