I just got finished adding DMX auto detect to my multi protocol Ren code. Once Phil finishes up, I will look at adding DMX support.
MartinMueller2003 wrote:I just got finished adding DMX auto detect to my multi protocol Ren code. Once Phil finishes up, I will look at adding DMX support.
Awesome!
Phil,
Thanks for not closing the door on this. I have a bunch of GECE pixels from multiyear Christmas closeouts and would love to use them with all of my other Renard controllers. Using the E68x is good, but if I can eliminate that different element from my display, that would be fantastic.
Long Live the Renard Controller !
P. Short wrote:Thanks for the offer, but at the moment I've got too many other things going on. It has never been my intention to have this design support a wide variety of different pixels, as I see that as the role of the E68x and similar products. This is not to say that supporting the GECE pixels will never happen, but that would either be later or by other people.
To all that have had a hand in this wonderful piece of hardware and firmware - THANK YOU.
This is going to fit in perfectly with the show that we are trying to expand.
The big question is this:
We have 14 Renard SS24s, all with the DMX firmware onboard, and several other Renard units (DC) that would be in the data stream. (I believe they also have DMX firmware.) Note that I believe they are all set to DMX Channel 1. These have worked together for 4 years now, one long data line, without a problem.
Can this PX1 be put at the end, or even in the middle, of that string? If so, what do we need to do special to make it work with its older brothers?
I freely admit I don't know as much about the Renard system that I should, but so far luck has been on my side.
Thank you for your input.
