Renard Pixel String...
 
Notifications
Clear all

Renard Pixel String Controller

258 Posts
50 Users
0 Reactions
121.7 K Views
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 20 years ago
[#24995]

I'm working on a PCB board (and firmware) design to control WS2811 pixel strings using the Renard system. The current PCB design is a 1.0" x 3.0" all through-hole board that is to fit inside a 1" PVC pipe.

The intent of this project (apart from providing me with a controller) is to make it as easy as possible for people already familiar with Renard controllers to get their feet wet using pixel strings. The other controllers out there are mostly DMX or Ethernet based, and the person who is currently using Renard controllers would need to learn to use one of these 'new' systems, which is not always easy for non-technical types. This project is meant to leverage the Renard equipment and knowledge that people already have.

Some Design Details:

1) One output (same 3.5mm connector and pinout as jstjohnz's controller), handling up to 200 pixels
2) RS485 input, same RJ45 pinout and protocol as Renard controllers
3) 115200 input baudrate (lower rates provided, but not recommended)
4) Uses PIC16 parts, so existing programmers should work.
5) Supports WS2811 strings at with either 400KHz or 800 KHz data rate, 5V power input
6) Uses external 5V supply (readily available from Ebay, China, etc).
7) Power, RxD and FE (framing error) indicators
8) Jumper to select pixel speed (400 KHz vs 800 KHz)

The PCB has been designed, with just a few details to be worked out after I receive some connectors to make sure that they fit. I haven't sent the board out for fab yet. The firmware is a work in progress, although I have verified that the microcontroller that I've selected can control the faster WS2811 pixels.


257 Replies
Posts: 127
(@s196635)
Estimable Member
Joined: 14 years ago

I'm excited!!


Reply
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago

Very interesting. I'm looking forward to see how this turns out. Is each board essentialy 3 channels of Pixel control, provided by Vixen?


Reply
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 20 years ago
rstehle wrote:Very interesting. I'm looking forward to see how this turns out. Is each board essentialy 3 channels of Pixel control, provided by Vixen?

Up 600 channels (200 'intelligent' RGB WS2811 pixels) under Vixen control, or any other program that supports the Renard protocol.


Reply
CaptKirk
Posts: 2200
(@captkirk)
Noble Member
Joined: 16 years ago

So being this runs at 115200, that does mean we do NOT currently have a way to be wireless, right? I guess we need to hope we can come up with something like an NRF24l01+ (or the like) solution for Renard to get to that baudrate, right? XBee is NOT going to work here...

THX.


Reply
Page 1 / 52
Share: