Mouser Out of Stock - Part Subtitution

**masterng** · 09-24-2009, 07:31 PM

Mouser is out of stock on a few items. I check the wiki for subtitution parts, but some parts don't have a sub listed:

Diode: Mouser# 625-1N5817-E3 / Manufacturer# 1N5817-E3/54
Crystal: Mouser# 520-TCH1843-X / Manufacturer# ECS-2100AX-18.432MHZ

Hope I can get all the parts from Mouser. Last time I have to split the order and got some from Digi-Key and the total cost became much higher... Thanks

**P. Short** · 09-24-2009, 10:50 PM

This is presumably regarding the Ren64-XC?

For the diodes any of the 1N5817 diodes that mouser lists in a DO-41 package will work.

For the crystal oscillator, try ACH-18.432MHZ-EK should work. It is cheaper and has a larger temperature range.

**joneslights** · 09-25-2009, 07:05 AM

Has anyone ever posted an "alternate" parts list? Mouser seems to be out if stock a lot lately. It would be nice to have. I know mouser will suggest parts but, that can get confusing.

**lizard050** · 09-25-2009, 07:50 AM

Do you think that crystal would work for the REn ss series. I don't know what these #'s mean but will it matter if the frequency stability # and the load capacitance #'s are different?

**christmas-light** · 09-25-2009, 07:56 AM

Hi

I buy those parts there is out of strock on ebay :p

C - L

**kostyun** · 09-25-2009, 09:07 AM

My last order of crystals for the Ren24 were on ebay - for $5 shipped I was able to get 20 crystals.

**masterng** · 09-25-2009, 10:31 AM

Sorry, didn't make it clear. I was looking for parts for the Renard SS. Could you experts confirm if the following will work for SS boards:

Crystal: 815-ACH-18.432-EK in place of 520-TCH1843-X

Diode: 625-1N5817-E3/4 in place of 625-1N5817-E3

Thanks

**P. Short** · 09-25-2009, 12:19 PM

My earlier comment applies to the Ren-SS boards as well.

**aaron09** · 09-25-2009, 01:49 PM

I just bought that same crystal from Jameco.com, for the same reason. They have two choices, I wasn't sure which one to purchase, so I just bought a handful of both, came to about 8 dollars or so.

I actually just received them, as well as everything else I needed from mouser today! Heating up the iron as we speak.

-Aaron

Edit: Here should be the right part number at Jameco.com for the crystal - 325649

**Wayne J** · 09-25-2009, 01:58 PM

Originally Posted by joneslights

Has anyone ever posted an "alternate" parts list? Mouser seems to be out if stock a lot lately. It would be nice to have. I know mouser will suggest parts but, that can get confusing.

http://www.doityourselfchristmas.com..._Substitutions