LedTriks Stand Alone programming issues
I was trying to get my tiny2313 chip to accept my standalone firmware, but all I could get AVRDUDE to do was read the chip. My command line is as follows:
avrdude -c usbtiny -p attiny2313 -u flash:w:SAtest.hex
I get the reading and it goes to 100% then it says avrdude done. There is no writing to the chip. I look at the ledtriks display and it flashes for a second then goes back to the original test pattern. I have looked at the code and I see my seven frames there. I tweaked the number of frames line to reflect the 7 that I have.
Am I missing something in the command line? This has been a weird endeavor for me. I try something then I run into a brick wall. I leave it alone for a couple of days and then come back to it and, viola, something works that didn't before. This whole thing has had me scratching my head.
2010 Plan: Hoping to maybe break the 100 channel marker.
2011 Plan: Finally hitting 116 channels!