Your ip in the second screenshot shows 192.168.1.101, not 192.168.0.101
Hello all
I almost have all my pixels going for this Christmas. On my Alphapix Classic from last year I am not getting output on all ports. I have tried everything I can think of so I am coming here to seek help from those more experienced than me.
The controller with the problem is an Alphapix Classic with a RPi4 connected by ethernet cable. The Pi is running FPP 6.0.2. I have attached some screenshots for your perusing.
Controller settings. The IP address when connected to the controller is actually 192.168.1.101. I had to change it to view/change the settings
controller.jpg
channel outputs.jpg
pihat.jpg
xlights config. The FPP that I am having issues on is FPP-House
xlights.jpg
Thanks
Sean
Your ip in the second screenshot shows 192.168.1.101, not 192.168.0.101
I had to change the IP of the controller so I could view and change the settings. I get output on ports 1-4
sorry I do see you already mentioned that
Your port and universe settings on the controller do not look quite correct. You have some over laps happening in because of the 512 channel max on a single universe. Going with a default of 510 channels since you cant the the last pixel in under 512, your ports on the controller will have different universes and start channels. Here is a website to do the calculations and a snip I did based on your setup. Hope it helps.https://www.wiltonlights.com/rgb-pix...el-calculator/
ports.JPG
Also on your FPP setup page, change the number of universes to 8 instead of 4 and leave the max channels at 510, that along with my post above should help out.
Bookmarks