Vixen 3 Issue with Show Sequential File

[AJVenti]

I am using Vixen 3.9u3, my set up is E1.31 to a Dmx bridge and to e1.31 controllers with an ethernet switch. Last year work great. This year when my show starts, I get an output to my switch but no signal form Vixen. I can go into vixen and reset up my controllers in the setup display. But after the show plays, and the power is removed I have to go back to the display setup and do it again to get it to play. My sequences will play if I open them one at a time. Not using the programmer. I also have two different start times on the same day and only the first one will play. the view log will open but not close

[jeffu231]

It does not make sense you would need to do the setup over to get it to play unless something in the system is changing. Can you post the logs and config screen shots so we can see if there is anything obvious there to start with.

[AJVenti]

I think I got it as long as I don't close the program it keeps the controller settings. Now I am hope that the Switch and DMX bridge get the signal at power up