Yup (well, not from that specific vendor).
They’re easily controllable.
Has anyone tested these out yet ? I just ordered a few 100 from China to test with .
Yup (well, not from that specific vendor).
They’re easily controllable.
I have some of the AP106 variant and they seem to work fine (also have some of the larger 8mm versions)...
A potential caveat is that they *should* have a 0.1uF decoupling cap added to each LED...
YMMV.....
I have a pile of them if you don't wanna have to wait till your shipment arrives.....
Hey that would be great if your not busy tomorrow possibly ? I have pulled out a Ren8 SS and will be around tomorrow most of the day.
Wil be around..
Promised myself I'd clean out the garage...
Mind you I have made the same promise every weekend this year....
I hear you there .I have procrastinated on outside chores also as the low temps/wind/rain so far this year don't add to the fun and provide the perfect excuse .
Thank you Bob for providing these pixel-leds so I could get an early jump on testing . These are great for building custom props and pcb related project . Now I will have a dozen more incomplete endeavours .
A couple of things to note is pinouts vary and color order needs to be factored . I will be increasing my order on these and converting my address numbers to support them . Also need to find an 8mm four legged part to for fritzing.
Bookmarks