Kulp 16A-B Hole Template for Bud Box

[jwilliams31]

I bought a kit from WiredWatts for the Kulp16A-B. It came with a bunch of cable glands. However the Bud Box did not come pre-drilled.

Out of curiosity, does anyone have a template for drilling the holes in the box for the pigtails, vent, etc.?

[pmiller]

I bought a kit from WiredWatts for the Kulp16A-B. It came with a bunch of cable glands. However the Bud Box did not come pre-drilled.

Out of curiosity, does anyone have a template for drilling the holes in the box for the pigtails, vent, etc.?

You can make your own template including the bottom for mounting everything. I don't use cable glands. They take up a lot of room and aren't really needed because water doesn't travel upwards.

Sent from my SM-T710 using Tapatalk

[MrLights2000]

You can make your own template including the bottom for mounting everything. I don't use cable glands. They take up a lot of room and aren't really needed because water doesn't travel upwards.

Sent from my SM-T710 using Tapatalk

What are those caps on the pops distro board? 3D prints? I’m interested in those! Nice setup


Sent from my iPhone using Tapatalk

[Kev7274]

Looks like 3d printed covers for the power connections?

[pmiller]

What are those caps on the pops distro board? 3D prints? I’m interested in those! Nice setup


Sent from my iPhone using Tapatalk

Those caps I 3d printed to protect from accidently shorting out anything. Also printed 682 mounts, temp sensor mounts and distro board mounts. The mount for the LED work light is also 3d printed as well as the case for the large volt meter.

Sent from my SM-T710 using Tapatalk