Problems opening a sequence saved from another computer

**Amigorick** · 12-24-2020, 07:52 PM

When I do a sequence on another computer with the same profile
As my show computer and then copy it and paste it into the sequence file
On the show computer, it opens but none of the channel programming is
There. All the channels are correct but none of the cells have any data. Why??
Using Vixen 2.1.

**rstehle** · 12-24-2020, 11:56 PM

Oh my, it's been so long since I used V2. I think that you can 'flatten profile in to sequence', then copy the sequence and load on to the other PC. Sequence should then play.

**jimboha** · 12-25-2020, 06:24 AM

Do you copy the attached profile into the Profiles folder?

Jimboha

**rstehle** · 12-25-2020, 10:49 AM

The profile is now part of the sequence.

**Amigorick** · 12-25-2020, 11:26 AM

Originally Posted by jimboha

Do you copy the attached profile into the Profiles folder?

Jimboha

Yes I made sure that the same profile was on both computers. I even attached it to the profile on the show computer
And it has all the correct channels but no data on any of them except when it is on the computer it was programmed on.

**Amigorick** · 12-25-2020, 11:28 AM

Originally Posted by rstehle

Oh my, it's been so long since I used V2. I think that you can 'flatten profile in to sequence', then copy the sequence and load on to the other PC. Sequence should then play.

I will try that!