Xlc-9

[wilmar]

Dikale is printing a bulb right now. Much better than the more expensive filament. Fun stuff!

Jeff

Yea but 2 moths ago it was 16.99 a roll and like everyone else they have raised the price to 20.99 already really boils my blood everytime I find a great inexpensive fillament they raise the price when people start buying it ugh


Sent from my iPhone using Tapatalk

[Jeff Millard]

Yea but 2 moths ago it was 16.99 a roll and like everyone else they have raised the price to 20.99 already really boils my blood everytime I find a great inexpensive fillament they raise the price when people start buying it ugh


Sent from my iPhone using Tapatalk

Naw, it's $16.99 right now. I got a gift card in a package left on the front porch. So I just bought 3 rolls $54.36. (I'll stop buying it for a bit... sorry. ;-))

Jeff

[wilmar]

Naw, it's $16.99 right now. I got a gift card in a package left on the front porch. So I just bought 3 rolls $54.36. (I'll stop buying it for a bit... sorry. ;-))

Jeff

But all you need I haven’t seen them run out yet lol


Sent from my iPhone using Tapatalk

[virgil1]

I got around to printing one of these, and I didn't bother to look at the dims. These are much bigger than 'normal' C9s, but the opening is the right size(ie the 'bulb' is really big, but the opening is just right). I attached a pic next to a C9 bulb from my 'Applights'. I an no expert in any 3d cad software, but is it easy to make it smaller? Height wise, it would need to be about 68% of the current size. If I use a slicer to just scale it down(which I did), the base is way too small. Using green filament...its what I had on hand, was checking size before I order the white filament.

IMG_1473.jpgIMG_1474.jpg

[wilmar]

I got around to printing one of these, and I didn't bother to look at the dims. These are much bigger than 'normal' C9s, but the opening is the right size(ie the 'bulb' is really big, but the opening is just right). I attached a pic next to a C9 bulb from my 'Applights'. I an no expert in any 3d cad software, but is it easy to make it smaller? Height wise, it would need to be about 68% of the current size. If I use a slicer to just scale it down(which I did), the base is way too small. Using green filament...its what I had on hand, was checking size before I order the white filament.

IMG_1473.jpgIMG_1474.jpg

I posted regular C9 as well


Sent from my iPhone using Tapatalk

[wilmar]

I got around to printing one of these, and I didn't bother to look at the dims. These are much bigger than 'normal' C9s, but the opening is the right size(ie the 'bulb' is really big, but the opening is just right). I attached a pic next to a C9 bulb from my 'Applights'. I an no expert in any 3d cad software, but is it easy to make it smaller? Height wise, it would need to be about 68% of the current size. If I use a slicer to just scale it down(which I did), the base is way too small. Using green filament...its what I had on hand, was checking size before I order the white filament.

IMG_1473.jpgIMG_1474.jpg

https://www.thingiverse.com/thing:4726557


Sent from my iPhone using Tapatalk

[virgil1]

Thanks!