Can you tap DMX off a LOR output?

[deonb]

If you control your LOR boards via DMX, and then you have another (real) DMX fixture past the end of your LOR controllers - can you just tap that signal off the last LOR board?

Or does the first LOR board translate its input DMX into the proprietary LOR protocol and every LOR board from that point onwards just talk LOR-protocol?

[MikeKrebs]

They will all respond to DMX.

[deonb]

They will all respond to DMX.

I know, but that’s not my question. My question is if they will continue to output DMX.

[algerdes]

MOST DMX devices do not regenerate the signal. They simply pass it on to the next device in the chain.
So, your question of "... will continue to output DMX" is a YES in most cases.

[Randomaker]

Yes you absolutely can, but you need to make an LOR to DMX cable because they use different pairs of wires.