how to access e682 page after ip change for FPP

[mrgimmeone]

I know it's porbably been asked before but how do i get access to my e682 controller page after i have changed it off my home ip range. My FPP wlan0 home range is between 192.1681.1 - 192.168.1.254 and in FPP i have set the controllers in the 192.168.100.xxx on eth0 range. So as of now i can't access them without resetting the ip on them to make any changes an then setting them back to the working addresses. I would just like to be able to access the these controllers and make some setting changes without having to reset the ip everytime. Thanks for any help

[K-State Fan]

Enable route box checked

Set up a route either on your computer or your router


Sent from my iPad using Tapatalk

[mrgimmeone]

enable route box is always checked for me. As far as setting up a route on the pc or router that is looking Greek to me even after searching all over on how to do that. but thank you for the response.

[K-State Fan]

There is a good pinned thread on the falcon forum with instructions on how to set up a route.

[Stormyblade]

There is a good pinned thread on the falcon forum with instructions on how to set up a route.

Falcon forum...falconchristmas.com?? What area/section?

[Ruppro]

Newer versions of FPP have "Proxied Hosts", that looks like you can setup your controller there and don't need to worry about messing w/ Routes. You add them in FPP, then there is a link you can click to connect to the controllers web interface.

Capture.JPG

Capture.JPG