Starting my first set up with pixels.

[Bwinter]

I’m pretty sure Falcon still sells power distribution boards, along with their Falcon PiCaps

[Cameron3395]

Something like this? https://www.pixelcontroller.com/stor...roller=productA69F0FBF-BAC4-4991-A4AA-B3A996BD8106.png

[Bwinter]

Yup

[Cameron3395]

Yup

Since I'm using a PiCap and it's only 2 channels, does that mean if I want to sync to some music it would only be two strings with motion or can I break down each of the 2 channels into more sections? Each channel will be about 350 pixels apiece so I though of doing 6 sections on roof and then the 4 windows. I've looked and googled but couldn't find that much about the PiCap except hooking up 2 small strings and turning them on.

[Bwinter]

You can break down each output into multiple sections (I.e., window, front roof, top roof, etc), and sequence each section independently.

[Cameron3395]

Awesome thanks!
Another question. The distribution board is where I will run all my injection wires to correct?

[Bwinter]

Correct.

Now would be a good time for you to draw up your wiring-schematic (not just lines on a picture of a house). It makes it easier for you to plan, and easier for the rest of us to reference if you have more questions.

[Cameron3395]

https://www.amazon.com/Grand-General...J0P134AEGXD297

Would this work good for my extensions between light sets? I would connect the connectors to them.

[Bwinter]

What connectors are you using?

[Cameron3395]

I have a few of the 13.5mm already but I can order different ones if I need to.