Hi all,
new to all this but learning fast, I hope.
I've started to look at using an Arduino Uno to help improve my display. I've also started using Vixen 3 and seem to have figured that out ok. I have created a new sequence and set the general serial controller. I only plan on running one small mega tree through the uno.
my question is how do you put the sequence onto the arduino uno ?
I've read alot about codes on the Uno as well as using fastled but so far I havent found anything that explains the process of moving a vixen 3 sequence onto the arduino so the sequence will then run on the pixels.
Any help would be great or even tutorials which are recommended to watch .
thanks all