FPP PB16 Pixel Controller

[mrpburke]

The main difference between the V1 and V2 is, V2 has surface mount components. Eeprom should be the same for either board.
If these are your first boards in this project, I hope you enjoy them as much as I have.

They have a different pinout and use different firmware so ya can’t use the v1 version file.

I think I’ve finally gotten a handle on how the eeprom is generated so I may try to make my own as a last resort.

[scooter_seh]

I have intentionally not posted the EEPROM for the V2 to prevent someone from selling them in mass without me knowing. If you DM me your email I can send it to you.

Thanks,
Scott

They have a different pinout and use different firmware so ya can’t use the v1 version file.

I think I’ve finally gotten a handle on how the eeprom is generated so I may try to make my own as a last resort.

[mrpburke]

I have intentionally not posted the EEPROM for the V2 to prevent someone from selling them in mass without me knowing. If you DM me your email I can send it to you.

Thanks,
Scott

Makes sense. I sent ya a PM. No rush though. It’ll be a while before everything comes in.

[rayhjr]

I'm looking at setting up a BBB16 in FPP Channel Outputs page. I noticed the page for the BBB16 doesn't have the Serial Mode drop down and start channel area like the PB16 page. Is it necessary? DMX ok to run on BBB16 without this info?
20220508_180346.jpg

[scooter_seh]

The BBB16 and PB16v2 use the builtin serial UART's that are configured on the other page

[rayhjr]

The BBB16 and PB16v2 use the builtin serial UART's that are configured on the other page

Yep. Right under my nose. Thanks Scott.

[Keith R]

Got my PB16 and expansion boards today. Looking forward to a new build.