Results 1 to 4 of 4

Thread: Xlights/Xschedule brightness adjustment

  1. #1
    Join Date
    Nov 2017
    Posts
    27
    Post Thanks / Like

    Default Xlights/Xschedule brightness adjustment

    Just made a simple sequence for my 1st mega tree, i have turned down the brightness within xlights and the programs runs fine directly from there but when I run the same program from xschedule the brightness seems very bright and the tree flickers very badly.
    Any ideas why this would be?
    Thanks

  2. #2
    Join Date
    Jul 2015
    Posts
    308
    Post Thanks / Like

    Default Re: Xlights/Xschedule brightness adjustment

    Are you outputting to lights from 2 programs at once?


    Sent from my iPhone using Tapatalk

  3. #3
    Join Date
    Nov 2017
    Posts
    27
    Post Thanks / Like

    Default Re: Xlights/Xschedule brightness adjustment

    No I would like to output my sequence from xschedule only if possible, only so I can loop my fairly short sequence over and over unless it can be done directly from xlights?
    Thanks

  4. #4
    Join Date
    Jul 2015
    Posts
    308
    Post Thanks / Like

    Default Re: Xlights/Xschedule brightness adjustment

    Right but the symptoms sound like two programs open sending data.


    Sent from my iPhone using Tapatalk

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •