Results 1 to 2 of 2

Thread: P5 panel matrix experiencing artifacts

  1. #1
    Join Date
    Jan 2011
    Los Banos
    Post Thanks / Like

    Default P5 panel matrix experiencing artifacts

    I have 12 P5 panels setup in a 3 x 4 configuration using a ColorLight 5A-75B receiver board. I am using 4 outputs on the receiver board feeding 3 panels each. I then use a Raspberry Pi 3B in bridge mode to send data from Light-O-Rama to the Matrix. My issue is if i use the GIF in the link below with LEDVISION software it appears perfectly, with good motion but when I send it with LOR through the Pi, it shows a lot of what I call artifacts as you can see in the video link below. I have tried adjusting the refresh rate of the receiver and nothing seems to help. These P5 panels are the 64 x 32 1/16 scan model if that sparks any ideas in anybody.

  2. #2
    Join Date
    Oct 2014
    Sauk City, WI USA
    Post Thanks / Like

    Default Re: P5 panel matrix experiencing artifacts

    Is the gif resized or is LOR doing that?

Tags for this Thread


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts