Results 1 to 3 of 3

Thread: Any way to avoid moisture in P10 build?

  1. #1
    Join Date
    Dec 2016
    Posts
    78
    Post Thanks / Like

    Default Any way to avoid moisture in P10 build?

    Hey guys, I built a 54 panel P10 screen, Wrapped the front in 3M clear plastic and its sealed all along the sides, then I used a clear table vinyl cloth to continued from the sides around to the back so its covering all electronics from getting wet, the issue is this morning I woke up and I saw some moisture build up all the way along the entire bottom about 2-3 leds up and a few LED's are just flickering now do to the moisture. Is there anyway to avoid this? Will I maybe not have this issue in the winter being it will be 30 degrees and not warm?

    The power supplies are on the outside of the screen so I know the heat from them is not causing any build up, just not sure what to do and wanted to nail this before I build a second one.

    Am I better off leaving a few areas in the back open to let it breathe a little in a way that it will still keep rain out?

    thanks!!
    Last edited by brichi; 06-04-2018 at 08:33 AM.

  2. #2
    Join Date
    Aug 2008
    Location
    Columbus, OH
    Posts
    4,078
    Post Thanks / Like

    Default Re: Any way to avoid moisture in P10 build?

    You will never keep all the water out unless you seal it in a vacuum.
    So, I would put weep holes in the bottom to allow condensation a way out.

  3. Likes TazChaLet liked this post
  4. #3
    Join Date
    Dec 2016
    Posts
    78
    Post Thanks / Like

    Default Re: Any way to avoid moisture in P10 build?

    ok cool, ill give that a try tonight

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •