I have been using 3 channels of a DIY e.131 Bridge to drive a nonpixel show for the last couple of years. I build a pixel extender and tested it on a string of pixabulbs last year. I was able to get it to work using the test pattern thing in the bridge configuration page and even to control the strand with vixen 3 playlists.

Earlier this year I preordered 650 pixels, strips, etc. and a couple more pixel extenders from DIYledexpress which have now arrived, but I can for the life of me figure out how to configure the bridge and extenders to work. Now I've monkeyed with things to the point where the pixabulbs don't even work right.

I set the output to WS2811 with 150 channels as a test, but the behavior doesn't make sense and I certainly can't control them. I just wanted to test the pixels before plugging them in the strips and am pretty frustrated.

I would appreciate any links to basic setup stuff or screenshots of how it should be setup.

Thanks in advance.