-
Re: MTM ACR4-18 Ammo Crate Enclosure

Originally Posted by
jchancel
As with everything else in life, I'm running behind schedule. I did actually get the design updated with beefier U Hangers for the power supplies that flex less. While the design is not in the main navigation of the designer site yet, you can actually see and customize the design via my staging area:
Here is the staging area if you are interested - the only thing you cant do is have it fabricated yet - Just look for the design labeled "MTM ACR8-72 Double Level Mounting Plate w/ Easy Remove Power Supplies"
http://www.jdeation.com/site/publicdesigns
Sounds good.
-
Re: MTM ACR4-18 Ammo Crate Enclosure

Originally Posted by
jchancel
Working on it, heres a preview of the easy remove power supply version for the MTM ACR8-72 - also fits the MTM ACR5-72... Just putting final touches on it and getting it ready for the website...

This one one i wanna check out.
-
Re: MTM ACR4-18 Ammo Crate Enclosure
I've been playing around and am trying to figure out where to put an expansion board for the Falcon F16v3. May just wait to see what the final design looks like.
-
-
Re: MTM ACR4-18 Ammo Crate Enclosure
That's the layout I finally had after messing with it some more, minus the fan and temp which is a good idea.
Sent from my SCH-I535 using Tapatalk
-
Re: MTM ACR4-18 Ammo Crate Enclosure
Here's what I came up with including the fan and temp sensor and added the knock out clamp a fuse holder.
00001.jpg
Last edited by Kev7274; 04-13-2018 at 07:03 PM.
-
Re: MTM ACR4-18 Ammo Crate Enclosure

Originally Posted by
Kev7274
Here's what I came up with including the fan and temp sensor and added the knock out clamp a fuse holder.
00001.jpg
Looks good. Think about where your wires are going to run. You might consider moving the fuse box to the left side of the expansion board. Also might consider putting some zip tie holes so you can make it all tight (look for these in the misc category)...
-
Re: MTM ACR4-18 Ammo Crate Enclosure

Originally Posted by
jchancel
Looks good. Think about where your wires are going to run. You might consider moving the fuse box to the left side of the expansion board. Also might consider putting some zip tie holes so you can make it all tight (look for these in the misc category)...
Yeah,that makes sense. I'll play around with it more to get a final layout.
Last edited by Kev7274; 04-14-2018 at 07:15 PM.
-
Re: MTM ACR4-18 Ammo Crate Enclosure
Got the MTM ACR-8-72 Enclosure officially on the website. http://www.jdeation.com/mtm_acr8_72
Also built a quick overview video:
-
Post Thanks / Like - 0 Thanks, 1 Likes
-
Re: MTM ACR4-18 Ammo Crate Enclosure
Sweet
Sent from my SCH-I535 using Tapatalk
Bookmarks