FPP and p10 panels set up problems

[wilky37]

hi all i have decided to add some p10 panels this year, i have watched all the videos i can find but unfortunately i can't get them to work. before i go to the desired Master and remote of both the pi's i am just trying to get it to work as a standalone player, was hoping someone could check out these screenshots of my setup just to make sure i have it set correctly , i am using a pi cap from Hanson electronics on my pi 3 model b. in the set up tab if i click output to led panels the FPP won't restart easily and when it eventually does it won't play a sequence that is stored on the memory stick, any help or advice greatly appreciated, Many thanks Ian

[ezellner]

Try updating your FPP to version 1.10 as indicated. There were fixes made specifically for panels that may address your issue. Which Pi cap from Hanson are you using (Octoscrolla?)?

[Barnabybear]

Hi,
Photo 2: Check the box 'Enable LED Panel Output'
Photo 3: As a 'Standaloan Player' you don't need to list the P10 Universes as E1.31 Outputs.

[wilky37]

Hi as i stated if i check that box the FPP acts up, won't play sequence and has trouble restarting

[MikeKrebs]

are you adding the sequence to the playlist? have it scheduled?

[wilky37]

hi, not having it scheduled just uploaded a test sequence and start it manually

[Barnabybear]

Hi, delete universes 4, 5, 6, 7, 8, 9, 10, 11 & 12 from your E1.31 setup. As it stands you are sending the data to both the P10's and out over E1.31.