Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: Can someone help? (Video)

  1. #11
    Join Date
    Oct 2014
    Posts
    7
    Post Thanks / Like

    Default Re: Can someone help? (Video)

    Ok so I have the new code put in. I closed the arduino IDE. I tried it with Vixen only and still the same issue. I am new to this. Where is the header value in Vixen?

  2. #12
    Join Date
    Oct 2014
    Posts
    7
    Post Thanks / Like

    Default Re: Can someone help? (Video)

    I am in New Mexico

  3. #13
    Join Date
    Dec 2014
    Location
    Southern California
    Posts
    810
    Post Thanks / Like

    Default Re: Can someone help? (Video)

    When you set up the controller in Vixen there is a window that pops up where you set the baud rate, start/stop/parity bits and a header and footer. When using Victor_PV sketch, you need to use 57600 baud and enter "~!" into the header field. Those characters will keep your Arduino in sync with the data from Vixen.

    I am in So California. You can call me if you like. I will PM my phone number. I am usually up to 11 - 12.
    Kevin

    2017 - Pi3 w/FPP controlling 8 ESPixelsticks driving 1250pixels and 3 Arduino MEGAS communicating with ESP-01s driving 96 channels
    2016 - 184 channels of Blinking/Flashing using 4 Arduino MEGAs and cheap home-made props.

Page 2 of 2 FirstFirst 12

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •