E1.31 bridge

[Keebler]

removed

[Keebler]

I find that the bridge helps a lot for a couple reasons:

1- E1.31 from the PC or Pi controlling the show. A single output setup.
2- Organization. Lay out your Renard daisy chains as needed for placement and short cable runs.

I had two bridges in use last year, and plan to go to three this year- the new one with pixel extenders. Here's last year's layout, if you are interested:

that's awfully pretty and quite well organized
there oughta be a law agin it

[mikeh65]

Did I copy you or you copy me. Amazing, my layout is very similar. Minus the PIXLITE, I don't have one, and I put one set of Renards on each bridge. Mainly because I located a bridge on each side of my display. I even have a standalone marquee with 6 panels running off of Ron's board on a Pi3. Scary.