Page 9 of 9 FirstFirst ... 789
Results 81 to 82 of 82

Thread: MonoPixel Animated Candy Canes

  1. #81
    Join Date
    Jan 2015
    Location
    Kansas City Missouri
    Posts
    1,581
    Post Thanks / Like

    Default Re: MonoPixel Animated Candy Canes

    Well, I got the chip programmed but everything stops there. I tried the "RenPX1Setup" application and it won't let me write because it needs a com port. I tried following "Configuring the Settings via a Renard Data Stream" but it doesn't make any sense to me. I'm guessing when the instructions were wrote up that an older version of Vixen was used because there's no options for selecting start address and channel especially when making a sequence. The setup I have is a Sandevices 6804 with output #1 set for Renard. I also tried setting up the 6804 as pixels and still no luck. Off the 6804 it's going to a 8 channel Renard and then the PX1 is daisy chained off that. The 8 channel Renard works perfectly. I even tried to disconnect the 8 channel Renard and go straight to the PX1 but nothing. All the lights on the PX1 are on except D3 (Attn). D3 will come on when Jumper J4 is installed.

  2. #82
    Join Date
    Feb 2009
    Location
    Plymouth, MN
    Posts
    8,766
    Post Thanks / Like

    Default Re: MonoPixel Animated Candy Canes

    Follow the standard setup information for the PX-1 as shown in the Wiki is about the best help I can give you with the PX-1. It uses the standard Renard data stream (not a pixel stream) so it shouldn't be too hard.

    http://www.doityourselfchristmas.com...xel_Controller
    http://digwdf.com

Page 9 of 9 FirstFirst ... 789

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •