I'm testing pixels that have recently arrived in the mail. They are soldered to RAy Wu's 3 pin pig tails and plugged into a falcon F16v2. I'm using 12v power supplies and 12v pixels. When connected to the board and the controller plugged in, all pixels are a very dim red/pink. If I use the test mode on the controller, they seem to function as normal but once I stop they go back to the red. I have double checked the connections and power is to power ect. I double checked Ray's store as well. Any ideas?
Edit: The picture below is connected with butt connectors because the first set wasn't working. I didn't want to solder those as I was looking for a quick connection. However, same results.
Sent from my iPhone using Tapatalk