DMX and Renard used together?

[montegut]

So new to this so any help appreciated. I want to use LightShow Pro with Renard for my static display of incandescent and LED's. Can I also use DMX thru an Enttec Pro fed by Cat5 / adapter out from the Renard board? Or can I use the LOR controller for 16 channels of static display with output to Enttec Pro to DMX controllers? Thanks

[budude]

You can run DMX to both Renard and LOR from the same Enttec Pro from LSP just fine. Note however that the wiring is different between the LOR and Renard. Look in the Wiki for the appropriate wiring. Basically pins 4/5 are the differential inputs but they're swapped around between Renard and LOR.

[montegut]

Thanks budude. I will start to play around with it and give it a try.