enable / disable channels button not working

[ballgame]

The "enable/disable channels channels for this sequence" button is working on my first sequence. However, the button is no longer active (gray-out) for any new sequence I try to create... Probably a simple fix/setup issue but I can't locate where to "re-activate" this function or figure out what is happening.

Any idea? Thanks

[DIY Sparks]

ballgame,
If you have made a PROFILE, and this "faulty" sequence is in that profile, then the sequence is bound to that profile's rules.

Hope that's clear. It's the most likely cause.

Stay tuned.


And welcome, by the way.

[ballgame]

It is clear and it makes sense. Thank you for the response.
What is strange about this is that it is the same profile that I used to create my first sequence which worked fine. Something has happened to it and I am not sure what and how.
If nothing else, I may have to recreate a new profile and see what happens. It would not be such a big deal, just a little time consuming; as a beginner, I was gearing up to start with 16 channels only. When the coop came up, I could not restrain myself to buy 2 Lynx Express controllers instead of 1 so I have to "upgrade" my profile anyhow.